Ford Gen II Mini-Starter – PN 3008

Applications: (See notes at bottom of page for more info)

255/289/302/351 Windsor Series V8 with manual trans and 164 tooth ring gear.
351 Cleveland V8 with manual trans and 164 tooth ring gear
170/200/250 Series L6 with 3/8" ring gear offset
240/300 Series L6 with manual trans
1982-1985 232 (3.8L) V6 trucks with manual trans

Compare RobbMc Starters with other starters

$299.00

PN 2025 Pinion Support Modification

Prevents pinion gear deflection on hard to start engines. Deflection can damage the pinion gear, the flywheel ring gear, and even the starter gear reduction assembly. Recommended for engines with any of the following:

Over 500 cubic inches
Over 11 to 1 compression ratio
Crank trigger ignitions
Magneto ignitions
More than 18° of ignition advance during cranking
Locked out or no distributor advance
Electronic start retard
Any engine that may kick–back during cranking

$30.00

PN 2014 Replacement Nose

Also known as the mounting block.

$49.00

PN 3020 Replacement Gen II Solenoid

Fits Gen II starters. Solenoid is held to starter with two screws.

$25.00

PN 2020 Replacement Solenoid

Fits older RobbMc starters. Solenoid is held to starter with three screws.

$20.00

Notes:

This starter has three mounting bolt holes. Only two are used on any given engine.
This starter has a register diameter of 4.133" and is designed for ring gears that are 3/8" from the starter mounting surface.
This starter is 8-1/16" long from the mounting surface to the end of the motor.
Replaces Lester numbers 3132, 3135, 3154, 3157, 3172, 3176, 3185.
The solenoid can be rotated to any position without taking the starter apart. We recommend positioning the solenoid under the starter motor and towards the oil pan. This makes it easier to connect the battery cable and keeps the solenoid away from exhaust heat.